Illuminate The Possibilities

CONSOLE RESET PROCEEDURES

 

Sometimes a console reset to factory setting is the only way to get a finicky console to behave. But, beware of what you are doing because you will wipe out all configuration information including your show. Always back-up your data, and when in doubt, give us a call first.

ETC Consoles (Obsession, Expression, Express, Microvision)
Most ETC consoles follow the same reset procedure: Hold down [7][8][9] on the keypad and turn the console off, and then back on. Do not release [7][8][9] until the console has rebooted. On some consoles you may get an error message [system software incompatible], just cycle the power again and the message will go away the board will be reset to factory defaults.

STRAND
Mantrix
Hold down the assign button and turn the console off. While still holding the assign button down, remove the A/C cable from the console. Wait 30 seconds. Replace the A/C cable. Turn the console back on. Release the the assign button.

LP90
Level one clear: Hold down the [CLEAR] button (the one on the alpha part of the keyboard, not the one on the numeric keypad) and turn the power off. Wait 30 seconds. Turn the power back on. Release [CLEAR]. Level two clear: Hold down the [CLEAR] button (the one on the alpha part of the keyboard, not the one on the numeric keypad) and turn the power off. Remove the A/C cord. Wait 30 seconds. Replace A/C cord. Turn the power back on. Release [CLEAR].